SEE PHOTOS
DESIGN:
Optimized for Aerotech System only
Router bits are shrinkfitted into reusable HSK20C holders
3 precision ground cutting edges
Unmatched rigidity and near zero runout achieved by the shrinkfit connection
Good chipflow and low heat retention is achieved by the three semi-polished flutes
Increased cutting edge durability from special submicron, extended life carbide
30° helix design with bottom cutting capability
APPLICATION:
For exceptionally smooth finishing cuts
Reduced run-out in parting cuts as 2 cutting edges are engaged at all times
Increased number or bite marks per inch reduce chip size and provide a smooth finish, important when edge-banding without pre-milling
Eliminates chipping, fuzzing and tear-out when the end of the upcut and downcut cutting edges are more than 1/16" from the top and bottom surfaces
When cutting rebates, dados or pockets, use an upcut length that is at least 1/16" shorter than the shallowest cut
If part movement is a concern, use an upcut length of 4.8mm (0.188") or shorter
IMPORTANT:
Dust (Chips) must remain moderately loose and unpacked in the cut to achieve optimal dust extraction
High upcut design is recommended for maximum dust extraction
MATERIAL:
Excellent finish on:
Laminated panels
Chipboard
Good finish on:
Softwoods and Hardwoods
MDF
Plywood, OSB
(requires Aerotech flange Type: GRILL)
